Instruction Manual

BEFORE proceeding with these instructions

verify the type of log set you have. Is it a DUAL

BURNER Set (Models MO18NG, MO24NG,

SH18NG, SH24NG, CSO30NG) OR an

INFRARED Set (Models GO18TIR or GO24TIR)?

1. If a DUAL BURNER Set proceed with the

instructions beginning below through

page 3.

2. If an INFRARED Set proceed with

instructions starting on page 4 continuing

through page 5.

SINGLE, DUAL & TOPSIDE SYSTEMS

(For Infrared Systems See Page 3)

INSTALLATION OF NATURAL GAS PILOT VALVE

This Safety Pilot Kit contains a Control Valve certied by C.S.A., which provides a safe and convenient way to

ignite your energy efcient gas log set.

Note: Use pipe compound on all male threads to seal joints.

A. This Safety Pilot Kit contains a Natural Gas Orice and L.P. Gas hardware. Instructions are packaged

separately in this kit.

B. Attach Pilot Bracket (Part #8) to the Burner Pan using one sheet metal screw (Part #9). Install sheet metal

screw into top left hole of the bracket (See Figure 1)

C. Attach the 3/8" straight Flared Fitting

(Part #4) to the Gas Control Valve

using pipe compound. (See Figure 2)

D. Attach Pilot Gas Supply Line

(Part #6) and the Thermocouple Lead

(Part #5) to the Gas Control Valve

Attach valve extension rod (Part #2)

to know and control valve.

(See Figure 2)

NOTE: When screwing into the

Control Valve, hand tighten both

the Pilot Gas supply line and

Thermocouple lead, then tighten

1/8 turn with a wrench. DO NOT

OVER TIGHTEN as this will cause

the Pilot to not function properly.

Figure 2

Figure 1

(A&B) Pilot Burner Assembly

STOP