Instruction Manual

Valve Body Assembly (cont.)
5. Attach the pilot bracket to the burner pan using the one (1)
sheet metal screw. (See Fig. 12)
6. Attach the pilot burner to the pilot bracket using the two (2)
bolts & nuts supplied. (See Fig. 13-14)
NOTE: Care should be taken not to kink the tubing which
 wouldrestrictgasowtothepilotburner.
7. Attach 3/8" swivel to the Main Burner Assembly. (See Fig. 15)
8. Attach Pilot Burner Assembly to the other end of the
3/8" Swivel. (See Fig. 16)
NOTE:Tightenallttingssecurelywithawrench.
9. Attach the pilot extension rod to the valve stem, then attach
the control knob to the extension rod. (See Fig. 17 - 18)
10. Place the assembled burner pan with gas control valve in the
center of the replace.
11. Connect the 1/2" gas supply line from the replace to the 3/8"
straight ared tting (Part #4) with the 3/8" ared tubing
supplied with the gas log set. Refer to General Insallation
Instructions section titled, "Connecting Gas Supply to Burner
Pan" for full instructions.
12. Test connections for leaks with soapy water, re-tighten if
necessary and re-test to determine if any leaks are present.
13. Refer to General Installation Instructions for granule, ember
grate and log placement.
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 16
Fig. 18
Fig. 17
INSTALLATION FOR
INFRARED BURNER SYSTEMS