Owner's manual

Grill Assembly
SIDE BURNER PARTS ASSEMBLY
11. Remove the two M5 x 8 Phillips head screws from
the orifi ce bracket. Align the orifi ce into the center
of the side burner bracket. (See Fig. 11)
12. Use the two screws removed in step 11 to secure
the orifi ce backet on the side burner tray.
(See Fig. 12)
Note: Add lock washer when installing the screws in
position.
13. Slide the side burner valve stem through the
center hole in the front of the shelf. Insert one valve
screw through the bezel and in to the side burner
valve and tighten. Next, install the second valve
screw through the bezel and tighten. Make sure the
bezel is installed with the OFF position facing up.
Install control knob, making sure to line up the fl at
side of the valve stem with the fl at side of the knob
stem. Unscrew the igniter push button from the
igniter module, install the "AA" battery with positive
end (-) facing out. Screw the push button back onto
the igniter. (See Fig. 13)
14. Attach the igniter wires to the igniter terminals.
(See Fig. 14)
Note: It does not matter which wire goes to which
terminal on the igniter module.
15. Place the side burner grate in position.
(See Fig. 15)
Note: Remove all the tape before using the grill.
Fig. 9
Side burner bracket
Fig. 10
Screws
Fig. 11
Fig. 14
8
Holes
Bolts
Side burner valve
Fig. 13
"OFF" on the bezel
vavle stem
Fig. 11
Orifi ce bracket
side burner bracket
Orifi ce
Fig. 12
Screws
Orifi ce bracket underneath the side burner tay
Fig. 15
Igniter
Igniter wires
Side burner
grate