Instructions / Assembly

3
20
0
40
60
80
100
120
140
160
Lubricator Regulator Filter
To compressor
To Palm Nailer
Quick Connector Quick Coupler
AIR CONNECTION SET UP
SPECIFICATIONS
Overall Dimensions: 4 x 3-1/4” x 5-1/4”
Capacity: 1 piece
Operating Pressure: 60 - 100 PSI
Air Inlet Size: 1/4” N.P.T
Weight of Tool: 1.88lbs.
min. 3/4" (50 mm)
Minimum Length Maximum Head
.43"
(11mm)
Magnetic Barrel
Leather cover, tool lubricant and allen wrench included
1/4 Male Quick
Release Connector
4
AIR SUPPLY
NEVER use oxygen or other bottled gases. Explosion may occur.
This nailer is designed to operate on clean, dry, regulated compressed air, between 60 and 100
psi. It is preferable to include an air filter, pressure regulator, and automatic oiler within 15 feet
of the tool, if possible.
An air filter is needed to remove contaminates and moisture that are contained in compressed
air; filtering will significantly prolong the life of the tool. If an automatic oiler is not installed,
place 2 to 3 drops of oil into the tool's air inlet twice a day. Do not install a quick coupler
directly into the tool. Higher pressure drastically reduces tool life.
The nailer comes factory-equipped with a male quick connector. The nailer must always be
connected to the air supply with a coupling that removes all pressure when it is disconnected.
NOTE: all components used with this nailer (air hose, connectors, regulators, filters, etc) must
be rated at 120 psi, OR 120% of the maximum compressor potential, whichever is higher. Do
not connect this nailer to a system with maximum potential air pressure greater than 200 psi.
! DANGER
Adjusting Air Pressure
Do not exceed 100 psi. Adjust the air pressure at recommended operating pressure 60 to 100
psi according to the length of nails and the hardness of the workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a
higher then required air pressure unnecessarily over stresses the Nailer.
! WARNING
OPERATION
APPLICATIONS
Including but not limited to: Toe-nailing, joist hanger installations, decking, framing,
tight corners.
FEATURES
-No trigger operation
-Lightweight, compact aluminum body
-Drives common nails in tight locations