Instructions / Assembly

Disconnect air hose from nailer:
before performing maintenance.
when clearing a jam.
when tool is not in use.
when moving it to another location.
when handing nailer to another person.
DO NOT place finger on trigger when disconnecting air hose - the nailer could fire when
reconnected to the air supply.
Carry nailer by the handle only, not by the air hose.
Do not drive nails close to the edge of the workpiece. It could split, allowing a nail to fly
or ricochet and causing personal injury. Do not try to drive nails at too steep an angle.
Make sure nailer is held firmly during firing to minimize recoil.
Do not drive a nail into very hard material, thin material, or on top of an existing nail- the
nail could ricochet, causing personal injury.
Never use the nailer if it is leaking air, the contact safety mechanism is not working,
nailer has missing or damaged parts, or requires repair. Make sure all screws and caps
are securely tightened.
Inspect the nailer before each use to insure that the trigger, safety mechanism, and
spring are operating properly. Lock the nailer in a clean, dry storage area between uses.
Only use parts, nails, and accessories supplied or recommended by FPC Corporation.
Unauthorized parts or fasteners can lead to malfunction and serious injury. Only
personnel trained by FPC Corporation or the distributor shall repair the product. Do not
modify this tool in any way.
Never use in presence of flammable liquids or gases. The nailer produces sparks during
operation.
Never use the nailer in sites containing lacquer, paint, benzine, thinner, gasoline, gases,
adhesive agents, and other materials which are combustible or explosive.
Check for live wires. Avoid the risk of electrical shock by checking for live wires that may
be hidden by walls, floors, or ceilings. Turn off the breaker switch pertaining to that work
area.
Do not store the nailer in a cold weather environment. Keep the nailer in a warm area
until the start of work. If it is in a cold area, bring it in a warm area and allow it to warm
up before use.
Manufacturer assumes no responsibility for consequential or indirect damages from the
use of this product.
Save this manual and have it available for tool operators
reference!
IMPORTANT SAFETY WARNINGS: continued
California Proposition 65
You can create dust when you cut, sand, drill or grind materials such as: wood,
paint, metal, concrete, cement, or other masonry. This dust often contains chemicals
known to cause cancer, birth defects or other reproductive harm. Wear protective gear.
2