User's Manual

CM2500W Amplifier - Installation Manual
18
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
• An omnidirectional antenna (CM288-W) must
be mounted vertically.
• A Yagi antenna (such as the CM230-W) must
be mounted horizontally and be aimed at the
desired cellular tower (line of sight).
CAUTION: MOUNT THE EXTERIOR
ANTENNA ON A FIXED STRUCTURE .
WARNING: FAILURE TO EXERCISE CAU-
TION WHEN WORKING IN HIGH AREAS
COULD CAUSE A FALL AND PERSONAL
INJURY.
WARNING: DO NOT TOUCH ANY LIVE
ELECTRICAL WIRES OR ALLOW THE
ANTENNA OR CABLING TO TOUCH ANY
LIVE ELECTRICAL WIRES.
1. Mount the antenna.
2. Connect a length of CM400 cable to the
antenna and tighten until hand-tight.
3. Run the cable along the planned route.
4. Install a properly grounded CMLP lightning
protector.
5. Seal any holes you make in the outside of the
building with appropriate caulking or sealant.
4.4 - Internal Antennas
Mount the interior antenna(s) in the location(s)
you selected during the planning process. Be sure
CAUTION: AVOID AIMING A YAGI
ANTENNA TOWARD ANY INTERIOR
ANTENNA .