User's Manual

CHAPTER 4: Installation
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
19
to follow the instructions included with the
antenna(s) for a safe installation. Remember:
• Dome antennas (CM222-W, etc.) should be
mounted in the ceiling as close to the center
of the desired coverage area as possible with
the domed side pointing down.
• Flat panel antennas (CM248-W) should be
wall-mounted as close as possible to center of
the wall at one end of long narrow space.
1. Mount the antenna.
CAUTION: VERIFY THAT ALL INTERIOR
ANTENNAS MEET THE SEPARATION
REQUIREMENTS DESCRIBED IN THE
PREVIOUS CHAPTER AND THAT NO
ANTENNA IS AIMED TOWARD THE
EXTERIOR ANTENNA .
2. Connect a length of CM400 or CM240 cable to
the antenna and tighten until hand-tight.
3. If you are installing multiple antennas, run the
cable to the splitter location and connect the
cable to one of the outputs on the splitter.
4. Connect another length of CM400 or CM240
cable to the input side of the splitter (if used)
and run this cable to the amplifier location.
4.5 - Mounting the Amplifier
Mount the amplifier as follows:
1. Verify that the selected location meets all of
the criteria described in the previous chapter.
CAUTION: DO NOT CONNECT AN
INTERIOR ANTENNA TO THE SPLITTER
INPUT.