User's Manual

CHAPTER 5: Configuration & Testing
Copyright 2011 Cellphone-Mate, Inc. All rights reserved.
23
5.2 - Initial Configuration
By default, your amplifier ships with all DIP
switches turned OFF to provide maximum gain in
all channels. This should always be your starting
point whenever installing or reinstalling the
amplifier.
5.3 - Powering on the Amplifier
To power on the amplifier:
1. Make sure both antenna cables are snugly
connected to the proper amplifier ports.
2. Plug a surge suppressor into a grounded
110VAC wall outlet.
3. Plug the AC end of the power adapter that
came with the amplifier into the surge sup-
pressor.
4. Plug the DC end of the power adapter into the
Power port on the amplifier
5. Power on the amplifier using the Power
switch.
6. Verify that the green Power light is illumi-
nated.
7. If the red Warning light illuminates, immedi-
ately power off the amplifier by either unplug-
ging the DC power supply from the surge
suppressor or by turning off the switch on the
surge suppressor. Increase the attenuation
CAUTION: ONLY USE THE POWER SUP-
PLY INCLUDED WITH THE AMPLIFIER.
USE OF ANOTHER POWER SUPPLY
COULD DAMAGE THE AMPLIFIER AND/
OR POWER SUPPLY.