User's Guide

SureCall | 48346 Milmont Dirve, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
17
4.5 - Mounting the Booster
Mount the booster as follows:
1. Verify that the selected location meets all of the criteria described in the previous chapter.
2. Attach the included mounting kit to the booster using the screws provided. Tighten the screws by
hand with a screwdriver until tight plus 1/4 to 1/2 turn. Do not over-tighten.
3. Mount 24” x 24”, 3⁄4” thick sheet of plywood on top of sheetrock into wall studs where the booster
is to be situated. Plywood should be ush against wall. Once mounted, screw the booster to the
plywood sheet. The top side of the booster with the lights and DIP switches should be facing away
from the wall and be plainly visible standing near the booster.
4. Connect the exterior antenna cable to the Outside Antenna port on the booster.
5. Connect the interior antenna cable to the Inside Antenna port on the booster.
6. Verify that all cable connections are tight and that the exterior and interior antennas are connected
to the proper jacks.
CAUTION: DO NOT POWER ON THE BOOSTER UNTIL
INSTRUCTED TO DO SO.
CAUTION: NEVER POWER ON THE BOOSTER WHEN
ANY ANTENNAS ARE DISCONNECTED AS THIS
COULD DAMAGE THE BOOSTER.
Installation