User's Guide

Table Of Contents

LED INDICATORS

Note: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is the ability to place and

hold a call.

Only the presence of a RED/YELLOW ash indicates the presence of an unresolved issue.

Important: The booster gain dials should remain at maximum level and only reduced if other recommended actions do not

resolve the issue.

LED Condition Status/Resolution

Initializing on

Power-up

All control lights ash RED & YELLOW for 5 seconds then off for 5 minutes.

GREEN SOLID Normal Operation

GREEN

FLASHING

Normal Operation.

YELLOW SOLID Normal Operation, Sleep Mode

YELLOW

FLASHING

Slowly

AGC has detected Insufcient separation between the inside and outside antenna automatically reduced

gain by 1 - 10 dB for the indicated frequency band.

This may be unavoidable in some situations where distance cannot be achieved.

After 5 minutes the frequency control light will return to SOLID GREEN

YELLOW

FLASHING

Quickly

AGC has detected signicant antenna isolation issues causing a reduction in gain between 10 and 20

dB for the indicated frequency band(s).

Adjustments should be made to improve your booster’s performance by following suggested methods

below.

After 5 minutes the frequency control light will return to SOLID GREEN

RED / YELLOW

FLASHING

Alternately

Extreme gain reduction (greater than 20 dB) resulting from insufcient antenna separation.

The frequency band has been disabled.

Adjustments are required to resolve condition.

RED SOLID Indicates the frequency band is manually turned off.

Keep in mind, identifying the setup that yields the best possible results for your environment will come from testing --

balancing the elimination of interference and while also receiving the best possible signal.