User's Guide
Table Of Contents
SureCall, Inc | 1-888-365-6283 | support@surecall.com | www.surecall.com SureCall, Inc | 1-888-365-6283 | support@surecall.com | www.surecall.com
10
Place the Inside Host
To install the booster to a wall, select a location that is near a working AC outlet. Use the supplied screws or appropriate
screws for surface of mounting location and drill through screw tab holes on booster (see “Booster Diagram” illustration) and
mount the booster to a wall.
Next, connect the outside and inside components by routing the outside cable from the outside amplier indoors and connect
to the booster port marked “OUTSIDE”.
Step 4: Connect to Power and Turn On
Connect the AC power cord to the booster and plug into a 110V AC power outlet. Once the booster has been completely
assembled, turn the booster’s power switch to ON.
Note: If the Power LED does not turn ON or the Alert LEDs continue to ash, see the ”Troubleshooting” on page 11
section.
Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury,
and void your warranty.
Power Jack
Power Switch
Connector to Inside Antenna
N connector to inside antenna
F connector to outside antenna
44
OFF
54
64
44
OFF
54
64
45
OFF
55
65
52
OFF
62
72
51
OFF
61
71
Screw tab holes for optional wall mounting
Booster Diagram