Fusion2Go ™ Adjustable 2G, 3G, 4G Vehicle Signal Booster Kit User Guide
Table of Contents Thank you for purchasing SureCall’s Fusion2Go cell phone signal booster kit. Fusion2Go provides enhanced 2G and 3G voice and 4G data reception and is configurable for any size vehicle. If you need any assistance during product installation please contact tech support at 1-888-365-6283 or email us at support@surecall.com. How It Works Pg. 3 Package Contents Pg. 4 Installation: Step1: Connect outside antenna Pg.5 Step 2: Connect inside antenna Pg.
How it works The SureCall Fusion2Go is a high-quality bidirectional booster that enhances cellular signals for cars, motor homes, and other vehicles. The Fusion2Go works with two antennas: • An inside antenna that communicates with your cell phone. • An outside antenna that communicates with the cell tower. Signals sent from a cell tower are received by the outside antenna, amplified by the booster and then sent to your cell phone via the inside antenna.
Package Contents 1. Unpack all package contents. For missing or damaged items, contact your reseller. 2. Turn over the signal booster and record the model and serial number for reference: Serial #: Purchase Date: 3. Keep the carton and packing material to store the product in case you need to return it.
Installation Installation Steps: Step 1. Installing your Hardware Connect the Outside Antenna 1. Connect the magnetic outside antenna to the roof of the car in a location that: • Is on top of the vehicle • Has at least a 12-inch radius clear of obstructions and other radiating elements, such as a radio antenna. • Is at least 4-6 feet from the inside antenna. 2. Using the supplied cable, connect the outside antenna to the booster connector marked OUTSIDE. 3.
Installation Step 2. Connect the Inside Antenna 1. Mount the inside antenna so it is: • W ithin 2-3 feet of the cell phone • Mounted on a surface that is at least 4” (10cm) away from metal. 2. Using the supplied cable, connect the antenna to the booster connector marked INSIDE 3. Hand tighten the connection Step 3. Install the Signal Booster 1. Mount the booster under the seat of the vehicle, or on the front or middle console of the vehicle.
Configure Gain Setting Booster Hardware The following image shows the key hardware components on the cellullar booster. Refer to this image as you install your Fusion2Go kit components. FME connector to inside antenna Power Switch Connector to Inside Antenna Power Jack FME connector to outside antenna SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | sales@surecall.
Troubleshooting In the event you encounter a problem, follow the suggestions below to resolve the issue. 8 Problem Resolution Signal booster has no power Verify that the booster power switch is turned on. Make sure the DC power outlet is plugged into the cigarette lighter adapter. If the green POWER LED on the signal booster is OFF, return the power supply to SureCall. Contact tech support at 1-888-365-6283 or support@surecall.com, or go to www.surecall.
Specification Product Name Fusion2Go Uplink Frequency Range (MHz): 698-716 / 776 – 787 / 824-849 1850-1915/ 1710-1755 ( G Block included ) Downlink Frequency Range (MHz): 728-746 / 746 – 757 / 869-894 1930-1995 / 2110-2155 ( G Block included ) Input Impedance: 50 Ω Maximum Gain: 50 dB Noise Figure: 5 dB VSWR: ≤2.
Warranty Marine Kit Component Prod No. Description Outdoor Antenna Gain/Loss 1900MHz LTE-A LTE-V 800MHz SC288W or Galaxy 5412-P 3dBi 3dBi 3dBi 4dBi 4dBi\4dBi Outdoor Cable SC240-40FN 40Feet 3.52dB 3.52dB 3.98dB 6.52dB 6.12dB\6.92dB Indoor Antenna SC248W 7dBi 7dBi 7dBi 10dBi 10dBi\10dBi Indoor Cable SC240-20FN 20Feet 2.06dB 2.06dB 2.29dB 3.56dB 3.36dB\ 3.76dB 1700MHz\2100MHz Notes Wall Mounted Antenna *All equivalent antennas and cables are suitable for use with the Fusio
Warranty and/or workmanship. Warranty returns must first be authorized in writing by SureCall. Disassembly of any SureCall product by anyone other than an authorized representative of SureCall voids this warranty in its entirety. SureCall reserves the right to make changes in any of its products without incurring any obligation to make the same changes on previously delivered products.
This is a CONSUMER device. BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person.
