Use and Care Manual

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
10
LED Indicators
IF YOU WANT TO IMPROVE PERFORMANCE
• Identify a location outside that receives a stronger signal and move the outside antenna to that location (higher is usually better).
• Increase the distance between the booster and outside antenna.
• See more tips and tricks or contact us at www.SureCall.com/support
TROUBLESHOOTING
If you have any questions during setup, please reach out to our US-based experienced support technicians:
Call: 1-888-365-6283, Email: [e-mail], or Visit: www.surecall.com/support
Problem Resolution
Signal booster has no power Connect the power supply to an alternate power source.
Be sure the power source is not controlled by a switch that can remove power from the outlet.
Check the POWER LED () on the signal booster. If it is OFF, contact tech support at:
1-888-365-6283 or [e-mail], or go to www.surecall.com/support
After installing your signal
booster system, you have no
signal or reception
Verify that cable connections are tightly tted to the booster and antenna.
Try further separating the booster and antenna.
Verify that there is usable signal where the antenna is placed.
Remember: Bars are not always a reliable measure of signal. The best way to conrm signal coverage is the
ability to place and hold a call.
OK
Best
Antenna Position
Best Antenna SeparationBest Antenna Separation
Booster LED Diagram
Left LED
Right LED
Power LED