Use and Care Manual

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
8
Ensure that the mounting area has at least a 12-inch radius clear of
obstructions and other radiating elements and orient the antenna
with the drip hole at the bottom.
Once you have identied your install location, assemble the u-bolt,
bracket, nuts and washers onto a pole or pipe (not provided) as
shown in the illustration. Keep the connections loose enough to
allow the antenna to rotate until the optimum direction is found.
Once the outside antenna is secured to a pipe or pole, connect
antenna to one end of the provided RG6 cable and tighten the
connection. Run the cable along route to planned location of your
booster.
Installation
Outside Antenna Assembly
Nut
Washer
U-bolt
Bracket
Drip Hole
RG6 Cable
Cable
Planned
Booster
Location
Outside
Antenna
min
i
mum
2
5 f
t.
sep
a
rat
i
o
n
Omni Yagi Antenna Install Illustration
Note: This booster is rated for 5-15V input voltage. DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury,
and void your warranty.
This booster should not be used near open re or ame. Storage and transportation: Store and place in non-extreme room-temperature and dry environment.