Use and Care Manual

SureCall | www.surecall.com | 1-888-365-6283 | [e-mail]
9
Installation
Step 3. Place the Booster
Place the booster in a central location where signal is needed
and at least 25 ft. from the outdoor antenna location. When
placing the booster, note that further separation between
the booster and outside antenna will increase booster per-
formance. Connect the open end of the RG6 cable from the
outside antenna to the booster and tighten connection.
Please note that the performance and range of your booster
depends on three factors:
1. Signal strength at the location of the outside antenna.
2. Interior building materials between the booster and your
mobile device.
3. Distance between the outside antenna and booster
(while at least 25 ft. separation is recommended, further
separation will increase performance).
Step 4: Connect to Power
Once the booster and outside antenna are connected and in
place, connect the power cord to the signal booster and plug
into a power outlet.
Enjoy Boosted Signal
Place a call in the room where the booster is located to con-
rm that your phone is receiving a boosted signal. Remem-
ber: Bars are not always a reliable measure of signal. The best
way to conrm signal coverage is the ability to place and
hold a call.
Placing Booster and connecting cable
Connecting the Power Supply
FCC 27.5 (d)(4): Fixed, mobile, and portable (hand-held) stations operating in the 1710-1755 MHz band as well as mobile and portable stations operating in the 1695-
1710 MHz and 1755-1780 MHz bands are limited to 1 watt EIRP.
Fixed stations operating in the 1710-1755 MHz band are limited to a maximum antenna height of 10 meters above ground.