FLARE™ 3.0 Cellular signal booster kit with combined booster and indoor antenna User Guide 10.26.
Table of Contents Introduction Thank you for purchasing SureCall’s Flare 3.0 cellular signal booster kit. SureCall’s Flare 3.0 was specifically designed to eliminate frustrations over dropped calls and limited range by amplifying incoming and outgoing cellular signals in homes and offices. If you have any questions during setup, please reach out to our US-based experienced support technicians: Email: support@surecall.com Or,visit: www.surecall.com/support @SureCall How it works ..........................
How It Works Package Contents PACKAGE CONTENTS How it works 1. An outside antenna collects signal from the cell tower. 2. The outside antenna sends the signal to the booster through coax cable. 3. The booster amplifies the cell signal and rebroadcasts the signal indoors to all mobile devices within range. 4. The booster amplifies outgoing cell signal back to the tower. Unpack all package contents. For missing or damaged items, contact your reseller.
Note that the outside antenna can be mounted to an exterior surface or a 1-2” diameter pole. A mounting pole is available separately (SC-J-Mount) . PVC piping from your local hardware can also be used. 3. Your planned location for the booster (central to where signal is needed) should be near an existing electrical outlet. 4. Ensure adequate separation between the planned locations of the booster and outside antenna (at least 25 ft.). 5.
Installation Installation Ensure that the mounting area has at least a 12-inch radius clear of obstructions and other radiating elements and orient the antenna with the drip hole at the bottom. Nut Washer U-bolt Bracket Once you have identified your install location, assemble the u-bolt, bracket, nuts and washers onto a pole or pipe (not provided) as shown in the illustration. Keep the connections loose enough to allow the antenna to rotate until the optimum direction is found.
Troubleshooting LED Indicators IF YOU WANT TO IMPROVE PERFORMANCE • Identify a location outside that receives a stronger signal and move the outside antenna to that location (higher is usually better). • Increase the distance between the booster and outside antenna. • See more tips and tricks or contact us at www.SureCall.
Specifications Kitting SPECIFICATIONS PreAGC PreAGC Pulse GSM 4.1 MHz AWGN Flare 3.0 (U.S.) ; Flare 3.0 CA (Canada) Frequency (MHz) Input (dBm) Output (dBm) Gain (dB) Input (dBm) Output (dBm) Gain (dB) Uplink Frequency Range (MHz): 698–716 / 776–787 / 824–849 / 1850–1915 / 1710–1755 Downlink Frequency Range (MHz): 728–746 / 746–757 / 869–894 / 1930–1995 / 2110–2155 Uplink: 1710-1755 -49.5 20.0 69.5 -49.0 19.4 68.
Consumer Guidelines Warranty CONSUMER GUIDELINES This is a CONSUMER device BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider.
SureCall, Inc 48346 Milmont Drive Fremont, California 94538, USA 888.365.6283 | www.surecall.