User Manual

ManualsBrandsSureCall ManualsAccessoriesSureCall Flare Cell Phone Signal Booster Kit for All Carriers 3G/4G LTE up to 2,500 Sq Ft

Step 2. Install the Outside Antenna

After identifying the area of strongest signal, choose the surface where you will mount the outside antenna.

Using the provided hardware, mount the outside antenna at the highest possible elevation, allowing a minimum

separation of 25 feet from the planned location of the booster.

The omni antenna is omni-directional, which receives and sends signals in a 360º radius. The

provided hardware allow for either a surface mount or pole-mount.

Mount antenna to a vertical surface:

1. Using vertical plate of bracket, mark position of desired placement. The omni antenna

should be mounted in an upright position (See “Omni Outside Antenna Install

Illustration” on page 9)

2. Unscrew nut from end of stucco screw and remove it along with lock washer and regular

washer.

3. Place vertical plate into desired location and tap the screws, head rst, along with

sleeve, into stucco 1/2 to 5/8 inches deep into place.

4. In this order, place washer, lock washer and nut on each screw and tighten until secure.

When tightening screw, sleeve will expand to secure plate.

5. Remove screws from antenna base and use to secure antenna onto horizontal plate.

6. Connect antenna to one end of the provided RG6 cable and tighten the connection.

Run the cable along route to planned location of your booster.

Note: Alternate screws may be required for differing surfaces such as wood or concrete.

Do not collocate antennas or operate the outdoor antenna with any other antenna or signal booster.

Installation Installation

Pole-mount hardware

Omni antenna with

surface mount hardware

Cable

Planned

Booster

Location

Outside

Antenna

ini

mum

5 ft

. s

par

Omni Outside Antenna Install Illustration

Nuts &

Washers

L-Bracket

Cable

Anchors /

Sleeves

Screws

Step 3. Place the Booster

Place the booster in a central location where signal is needed and at least 25 ft. from the outdoor antenna location.

When placing the booster, note that further separation between the booster and outside antenna will increase booster

performance. Connect the open end of the RG6 cable from the outside antenna to the booster and tighten connection.

Please note that the performance and range of your booster depends on three factors:

1. Signal strength at the location of the outside antenna.

2. Interior building materials between the booster and

your mobile device.

3. Distance between the outside antenna and booster

(while at least 25 ft. separation is recommended, further

separation will increase performance).

Placing Booster and connecting cable

Note: This booster should not be used near open re or ame. Storage and transportation: Store and place in non-extreme room-temperature

and dry environment.