Full Product Manual

ManualsBrandsSurecall ManualsElectricalFusion4Home Omni/Panel Cell Signal Booster Kit

Table Of Contents

1. Using vertical plate of bracket, mark position of desired placement. The omni

antenna should be mounted in an upright position (See “Omni Antenna Install

Illustration”)

2. Unscrew nut from end of stucco screw and remove it along with lock washer and

regular washer.

3. Place vertical L-bracket plate into desired location and tap the screws, head rst,

along with sleeve, into stucco 1/2 to 5/8 inches deep into place.

4. In this order, place washer, lock washer and nut on each screw and tighten until

secure. When tightening screw, sleeve will expand to secure plate.

5. Use provided screws to secure antenna base onto horizontal plate.

6. Connect antenna to one end of the provided RG6 cable and tighten the

connection. Run the cable along route to planned location of your booster.

Note: Alternate screws may be required for differing surfaces such as wood or concrete.

Nuts &

Washers

L-Bracket

Cable

Anchors /

Sleeves

Screws

Omni Antenna Install Illustration

Step 3. Install the Booster and Inside Antenna.

Choose a location for the booster and inside antenna that is near a working outlet and at least 25 Ft from the

outside antenna. Consider the below factors affecting booster performance.

1. Signal strength at the location of the outside antenna.

2. Interior building materials between the inside antenna and your mobile device.

3. Distance between the outside antenna and inside antenna (minimum 25 ft. separation)

Note: This booster should not be used near open re or ame. Storage and transportation: Store and place in non-extreme room-temperature and dry environment.

Installation

Yagi Antenna Assembly

Nut

Washer

U-bolt

Bracket

Drip Hole

RG6 Cable

Outside

Antenna

Yagi Antenna Install Illustration

Caution: Do Not aim a directional antenna towards another antenna

Aiming Directional

Antennas

Pole-mount hardware

Omni antenna with

surface mount hardware

Option B: Outside Yagi Antenna

Before installing a Yagi, or directional antenna, note that the antenna should be mounted on a pole or pipe (not

provided), at the highest possible location above the rooine – at least 25 ft above the indoor antenna – aimed

in the direction of your nearest cell tower. To nd the location of your

carrier’s closest cell tower, go to www.antennasearch.com.

Ensure that the mounting area has at least a 3 ft radius clear of

obstructions, other radiating elements and metal objects such as pipes or

metal siding and orient the antenna with the drip hole at the bottom.

Once you have identied your install location, assemble the u-bolt, bracket,

nuts and washers onto a pole (available separately) as shown in the illustration. Keep the connections loose

enough to allow the antenna to rotate until the optimum direction is found.

Once the outside antenna is secured to a pipe or pole, connect antenna to one end of the provided RG6 cable

and tighten the connection. Run the cable along route to planned location of your booster.