Use and Care Manual

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
11
Installing your Hardware
4. Connect the outside antenna cable to the signal booster connector marked OUTSIDE.
Hand-tighten the connection.
5. Connect the inside antenna cable to the signal booster connector marked INSIDE.
Hand-tighten the connection.
6. Connect the AC power cord to the signal booster.
7. Connect the plug on the other end of the 110V AC power outlet.
8. Turn the booster’s power switch on.
Booster Hardware
The following image shows the key hardware components on the booster.
Refer to this image as you install your Fusion4Home kit components.
Note: If the Power LED does not turn ON or the Alert LEDs continue to ash, (see PAGES 15-16).This booster is rated for 5-15V input voltage.
DO NOT use the booster with a higher voltage power supply. This can damage the booster, cause personal injury, and void your warranty
Power Jack
Power Switch
Connector to Inside Antenna
N connector to inside antenna
F connector to outside antenna
SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
11