Use and Care Manual

If you Want to Improve Coverage

1. Find a location that receives a stronger signal and relocate the outside antenna to that location

or, for the Yagi antenna, optimize the antenna angle.

2. Increase the distance between the outside and inside antennas.

3. Be sure your signal booster’s dB gain is turned up to maximum gain on each dial.

Installing Your Hardware

Note: As you can see from the table above, acquiring the recommended indoor and outdoor antenna separation optimizes coverage signicantly. Any

reduced antenna separation reduces the booster’s cellular signal capabilities.

WARNING: Do not attenuate the uplink and downlink dB settings below 35dB. This could cause the

aected frequency band to shut down.

Step 5. Congure Gain Settings

The SureCall gain dials should always be at maximum level unless the control light in a specic

band is ashing red or ashing red-yellow. In either of these

cases, the rst action should be to increase the antenna

isolation between the inside and outside antenna as much

as possible and restart the booster. If the situation contin-

ues, you can lower the gain with an attenuator or, as the

last resort, reduce the booster gain by 5dB at a time until

the control light in the frequency band ashes yellow.

1. Find the PCS, Cellular, LTE-A, LTE-V and AWS dials on

top of the signal booster.

2. Set the dials according to the coverage area and the

distance between the indoor and outdoor antennas (see

below).

If Coverage Area is … And Antenna Separation is… Set all Dials to…

1500 - 2,000 square feet 40-60 feet Maximum Power

1,000 - 1,500 square feet 30-40 feet 55 or 60

1,000 square feet and below 20-30 feet 45 or 50

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | sales@surecall.com