User Guide

SureCall | 1-888-365-6283 | [e-mail] | www.surecall.com
10
Planned
booster
location
Outdoor
Cable
Outdoor Omni
To mount antenna to a vertical surface:
1. Using vertical plate of L-bracket, mark position of desired placement.
2. Place vertical L-bracket into desired location and tap the screws, head rst, along with sleeve,
into stucco 1/2 to 5/8 inches deep into place. (Note: Alternate screws may be required for
different surfaces such as wood or concrete.)
3. In this order, place washer, lock washer and nut on each screw and tighten until secure. When
tightening screw, sleeve will expand to secure plate.
4. Use provided screws to secure antenna base onto horizontal plate.
5. Connect antenna to cable connector for the outdoor cable provided with your kit and run along
route to planned location of your booster.
Mast
(not provided)
Cable
L-Bracket
U-Bolts
Washers
Nuts
Cable
Anchors /
Sleeves
Screws Washers
Nuts
L-Bracket
Mast
(not provided)
Cable
L-Bracket
U-Bolts
Washers
Nuts
Cable
Anchors /
Sleeves
Screws Washers
Nuts
L-Bracket
Surface Mount
Pole Mount
Pole-mount
hardware
Omni antenna with
surface mount
hardware
InstallatIon