User Guide

SureCall | 1-888-365-6283 | [e-mail] | www.surecall.com
14
Step 4. Install the Signal Booster
1. Select a location close to a working AC outlet. Do not expose the signal booster to excessive
heat, direct sunlight, moisture, and airtight enclosures. If you’d like to mount the booster to a wall,
mark location of screw tabs on the wall in the desired location.
2. Use supplied or appropriate screws for surface of mounting location and drill through screw tab
holes on booster.
3. Connect the outside antenna cable to the signal booster connector marked OUTSIDE and tighten
the connection.
4. Connect the inside antenna cable to the signal booster connector marked INSIDE and tighten the
connection.
5. Connect the AC power cord to the signal booster.
6. Connect the plug on the other end of the 110V AC power outlet.
7. Turn the booster’s power switch on.
Power Jack
Power Switch
Connector to Inside Antenna
N connector to outside antenna
N connector to inside antenna
Booster Hardware
The following image shows the key hardware components on the cellular booster. Refer to this
image as you install your Fusion5s 2.0 kit components.
Note: This booster is rated for 5-20V input voltage. DO NOT use the booster with a higher voltage power supply.
This can damage the booster, cause personal injury and void your warranty.
Note: Power LED does not turn ON or the Alert LEDs continue to ash, see PAGE 15.
InstallatIon