User's Manual

10. Low Battery Indicator

Batteries last typically for at least 6 months with normal levels of use. When the batteries are

nearing the end of their life, the low battery indicator comes on. This is a slow red ash of the

indicator lamp, once every 5 seconds. The unit will continue to operate when the low battery

indicator is on, however the batteries should be replaced at the earliest opportunity.

Note the slow ash of the lamp (every 5 seconds) for the low battery indicator is different from

the fast ashing (every second) in learn mode. Learn mode should not be used when the

batteries are low – replace the batteries before programming a new microchip or collar tag into

the memory.

11. Memory Wipe

It is very unlikely that you will need to wipe a cat’s microchip or collar tag code from the cat ap’s

memory. Up to 32 different codes can be stored in memory, and if more additional codes are

learnt these simply replace the earliest ones stored. You can also change a cat’s permissions

at any time, as described in section 5.3. However, in the unlikely circumstance that you need

to wipe the memory (e.g. you accidentally programme for next door’s cat!), follow the process

below.

1. Press and hold the memory button for at least 10 seconds.

2. The indicator lamp will stay on for the duration that the button is held down.

3. When the memory is wiped, the catch will open and close once.

4. At this point the memory is clear and the cat ap can re-learn your cat(s) microchip

numbers, as required.

12. Switching Off/Use As A Non-Selective Cat Flap

In the event that you want to turn off your DualScan cat ap and revert to using it as a standard

cat ap (so that any cat can exit or enter at any time), follow the four steps below:

1. Remove the battery cover and make sure batteries are installed.

2. Press the memory button once to put the cat ap into learn mode. The catch will open and

the indicator lamp will ash green.

3. Remove the batteries and replace the battery cover.

4. The catch will stay open and the DualScan cat ap can now be used as a standard cat ap.

This mode may be useful if you have purchased the DualScan cat ap before your cat has

been microchipped or while your cat is getting used to the presence of its new cat ap (see

troubleshooting guide). Alternatively, the SureFlap RFID Collar Tag is available if your cat is not

yet microchipped.

Note: Keep indoor-only cats out of the room with the cat ap in when operating as a non-

selective cat ap.