‘Four Seasons Professional Stainless Steel Grill: 30”, 38” & 48” Models USE AND CARE MANUAL FOR.
SAFETY INSTRUCTIONS IMPORTANT SAFETY INFORMATION Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury Extreme care should he used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED ‘This appliance must he kept clear from combustible materials, gasoline or other flammable vapors and liquids.
1)0 N0’l’ store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other app1iancc. \%ARNING DO NO’I’ try lighting this appliance Grill Assembly . without reading the “I.IGHTING INSTRUCTIONS” section of this manual IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling. LEFT SHELF ASSEMBLY 1.
Grill Assembly 5. Slide the valve assembly through the center hole in the front of the shelf. (See Fig. 5) 6. Insert one valve screw through the bezel and in to the side burner valve arid tighten. Next, install the second valve screw through the bezel and tighten (See Fig. 6) 7. Press the side burner assembly upward into the side burner tray (See fig. 7) and Install two (2) self tapping screws from the top of the tray. (See Fig. 8) 8.
Grill Assembly Igniter Assembly 1. The battery, spring and igniter cap must be installed before using. 2. Slide the tnreauec1 part or irie igniter through the mounting bracket and then through the igniter hole in the front of the side burner shelf, then install the locknut. (See Fig. 13) 3. Slide spring assembly over the negative side of the battery. (See Fig. 14) 4. Install the battery, positive side first. (See fig. 14) 5. Screw igniter cap onto igniter. (See Fig. 15) 6.
L2J~ANKJNFORMATlON Never use a dented or rusted L.P. tank or cylinder with a damaged valve. L.P. cylinders are equipped with an O.P.D (Overfilling Prevention Device). The device shuts off the flow of gas to a cylinder after 80% capacity is reached. This limits the potential for release of gas when the cylinder is heated, averting a fire or possible injury. The L.P. cylinder must have a shut-off valve terminating in an LP gas supply cylinder outlet specified, as applicable, for connection No.
Apply the soap solution to connections of the fuel supply assembly. If no soap bubbles appear, there is no gas leak. If bubbles form at the connections, a leak is detected. If a leak is detected, immediately turn off the gas supply, tighten any leaking fittings, turn gas on, and repeat steps 1-3. 4. Turn off the knob on the fuel supply cylinder. 5. Turn on the burner control knobs for a moment to release the pressure in the hose, then turn the control knobs back off. 6.
Fig.
Lighting the Grill BEFORE 2, Open the gas supply valve located on top of your LIGHTING LP tank, A WARNING ATTENT1ON~ When turning the L.P. tank on, make Important! Before sure to open the valve vary SLOWLY two (2) complete turns to Insure proper gas flow. Lighting... Check the gas 3. Always open the hood before attempting to light. supply line for 4Push and turn one of the control knobs counter clockwise to the 1HIGH~’ position and immediately press the electronic igniter button.
Using the Grill WARNIING minimum of 12” from the sides Do not use the and back must be maintained from the gas grill above and below grill in the cooking surface to adjacent garages, breezeways, vertical combustible construction. sheds or any enclosed area. Clearance to non-combustible Never operate construction A minimum of 6” clearance from tile back of the grill the grill in to non-combustible construction is enclosed areas as this required for the lid to fully open.
Care and Maintenance DRIP TRAY The drip tray should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless It Is covered. Ruin water can collect Inside of the grill, the grill nati or the drip tray if left uncovered.
BEFORE CALLING CUSTOMER SERVICE If the grill does not function properly, use the following checklist. PROBLEM - SOLUTION Grill will not light when the igniter button is pushed. Is your gas supply turned on? Is there gas in your L.P, tank? Check your gas level Is one of your burners turned on? Allow up to four seconds of gas flow to ignite.
Component Stainless Steel Panels: Burners: Valves, Knobs, Electronic Igniter, Other related parts Warranty Period Limited Lifetime Limited 5 Years Limited 1 Year If the Sonoma Platinum Edition Grill does not operate properly, first thoroughly, carry out the instructions provided with the unit to ensure that the appliance is installed correctly and check the troubleshooting section in the use and care manual. • The warranty is non-transferable. • The warranty is for replacement of defective parts only.
