User Guide

Grill Assembly

Igniter Assembly

1. The battery, spring and igniter cap must be installed before using.

2. Slide the tnreauec1 part or

irie igniter through the mounting bracket and then through the

igniter hole in the front of the

side burner shelf, then install the locknut. (See Fig. 13)

3. Slide spring assembly over the negative side

of the battery. (See Fig. 14)

4. Install the battery, positive side first. (See fig. 14)

5. Screw igniter cap onto igniter. (See Fig. 15)

6. Attach the large end of the side burner wire to the terminal spade of the side burner electrode.

(See Fig. 16)

7. Attach the three (3) wires coming out from the side of the grill and the side burner wire to the

igniter terminals. (See Fig. 17)

NOTE: It does not matter which wire goes to which terminal on the Igniter.

LP hose/

regulator

supplied

(Type 1

connector)

INTERIOR PARTS ASSEMBLY

I. insert the top row of flavor grids into the cutouts with triangle ridges facing up (See Fig. 18)

2. install cooking grates on the ledges provided on the grill to create your cooking surface. (See

Fig. 19)

3. Rest warming shelf on four (4) slots above cooking grid. (See Fig. 19-20)

Gas Requirements

LR G.~S INSTALLATION

Sonoma Gas Grills are set to operate with L,P. gas and come with a high capacity hose and regulator

assembly. (Note! Only use the pressure regulator and hose assembly supplied with the gnu or a

replacement pressure regulator and hose assemblies specified by Sonoma). This assembly is designed to

connect directly to a standard 20 lb. L.F’~ cylinder. L.P. Cylinders are not included with the grill. L.P

Cylinders can be purchased separately at an independent dealer.