User Guide

Lighting the Grill
BEFORE
LIGHTING
A WARNING
Important! Before
Lighting...
Check the gas
supply line for
cuts, wear or
abrasion. Always
keep your face
and body as tar
away from the
grill as possible
when lighting.
LIGHTING
Lighting the Grill
with electronic
Igniter
1. Make sure all
control knobs are
in the
“OFF”
position.
2, Open the gas supply valve located on top of your
LP tank,
ATTENT1ON~ When turning the L.P. tank on, make
sure to open the valve vary SLOWLY two (2) complete
turns to Insure proper gas flow.
3. Always open the hood before attempting to light.
4Push and turn one of the control knobs counter
clockwise to the
1
HIGH~’ position and immediately
press the electronic igniter button. You will hear a
snapping Sound. It may be necessary to hold the
electronic starter button for about 4 seconds. (See
Fig. 21)
NOTE: if the burner does not light In 4 seconds, turn
the knob to the “OFF” position and wait 5 minutes
before trying again
5. Repeat above steps to
light remaining burners.
Match Lighting
It by chance the electronic igniter does not light the
burner, the burner may be lit with a match attached to
the match extender, located on the inside of the cart
door.
Keep your face as far away from the grill surface as
possible and pass the match extender through the
spaces in the grill grates to the ports of the back
crossover burner between the flavor grids. Position the
match near the burner ports and push and turn the
control knob counter clockwise to the “HIGH” position.
(See Fig. 22-23)
The match extender car be stored inside the cart doer
by sliding the extender ring through the opening on the
Inside. back of the cart door (See Fig. 24-25)
NOTE: if the grill will not light after several attempts
see the trouble-shooting section of this manual. Turn
the control knobs to the OFF position when not in use.
8