Full Product Manual

SURESILL™ WATER MANAGEMENT GUIDE
FOR WINDOWS AND DOORS
*1
© Copyright 2004 – 2010 SureSill, Ltd. All rights reserved.
STEP 4
Apply S
S
S
u
u
u
r
r
r
e
e
e
S
S
S
i
i
i
l
l
l
l
l
l
B
B
B
o
o
o
n
n
n
d
d
d
TM
2
2
2
0
0
0
0
0
0
0
0
0
sealant at jambs and
head.
STEP 7
Install waterproofing
HEADFLASH™ ASSEMBLY
Measure the exterior width of the window/door, including any brick
mold, and cut the DrainShield
TM
to that measurement. Check fit with
end caps before gluing. Remove any labels from contact surfaces.
Apply Wet-R-Dry
TM
PVC cement to contact
surfaces on both End Caps and
DrainShield
TM
(shaded area).
Slide End Caps fully in
place. Wipe excess PVC
cement. Hold glued parts
for 1 min for PVC cement
to dry.
Cut the channel plate ¼” smaller than the rough opening.
Check the fit with end caps before gluing them. See Sill
Pan Assembly DETAIL on page 3.
Weep Holes
SureSill
TM
Sloped Sill Pan™
Channel Plate
End Cap
End Cap
THE SURE
LEVEL OF
PROTECTION
SLOPED SILL PAN™ ASSEMBLY
Apply Wet-R-Dry
TM
PVC cement to contact
surfaces on both End Caps and Channel Plate
(shaded area).
Slide End Caps fully in
place. Wipe off excess
PVC cement.
Page 1 of 3
SAF – Henkel TeQ::Flash Butyl; DuPont™ FlexWrap™, DuPont™ StraightFlash™, DuPont™ StraighhtFlash™ VF; FortiFlash® Butyl
SEALANT – Henkel/OSI® TeQ Seal™; FOAM – DuPont/OSI® TeQ Foam™; Moistop® Sealant
RECCOMNDED
PRODUCTS