Installation Guide

Tools & Materials needed to install end panels and/or veneers:

 Tape measure

 150 grit sandpaper or sanding block

 Utility knife

 Table or Circular Saw

 Router (if available)

 J-Roller/Wood scraper

 Tack cloth

 Mini-Vac

 Hammer

 putty knife

 3’ straight edge

 Contact cement or adhesive

 Wood glue

 Finishing nails (optional)

Tips for Installing Veneers:

Critical: Veneers should be placed flat and allowed to acclimate for 48 hours before installation.

Surface Prep: Fill in any voids on the surfaces with wood putty. Lightly sand any surfaces you plan to cover. Clean the

area and wait for the it to thoroughly dry. Do not use a power sander. Use a tack cloth to remove excess dust.

Cutting: Use a veneer/laminate slitter, rotary cutter, or sharpened utility knife/straight edge to cut the veneer. Cut the

veneer strips ½” wider and 2” longer than the area you plan to cover (stiles/rails). We recommend doing the stiles first and

then the rails. Apply the veneer strips to one opening at a time.

Adhering: Poly Back veneers are best applied with roller grade adhesives. Be sure to cover both the veneer and substrate

surface with adhesive to ensure proper adhesion and performance.

Finishing: Use a razor knife to remove the excess material and finish with a hand file or 150 grit sand block to trim the

excess material.

PAGE 1
Tools & Materials needed to install end panels and/or veneers:  Tape measure  150 grit sandpaper or sanding block  Utility knife  Table or Circular Saw  Router (if available)  J-Roller/Wood scraper  Tack cloth  Mini-Vac  Hammer  putty knife  3’ straight edge  Contact cement or adhesive  Wood glue  Finishing nails (optional) Tips for Installing Veneers: Critical: Veneers should be placed flat and allowed to acclimate for 48 hours before installation.