USER MANUAL SurgeX SU1000Li Line Interactive 1000VA UPS with Automatic Voltage Regulation Surge Eliminator / Power Conditioner
SU1000Li Manual INTRODUCTION....................................................................................................................................... 2 INSTALLATION ........................................................................................................................................ 2 120 VOLT CONNECTIONS ............................................................................................................................... 2 BATTERY CONNECTION ......................
SU1000Li Manual INTRODUCTION The SU-1000Li is a 1000 VA line interactive uninterruptible power supply, surge eliminator, and power conditioner in a magnetically shielded steel enclosure. It operates from 120 volts AC and has a 6-foot, grounded, 3-wire #14 line cord. It has 4 grounded AC receptacles and two of these provide battery back-up protection. Overall dimensions are 3.5” H x 19.0” W x 10.5” D. Weight is 32.0 pounds.
SU1000Li Manual USB Communications Port Connection (optional) The Power Monitoring Software can be used with the UPS. Use the interface cable that comes with the UPS. Connect one end of the USB cable to the USB communications port on the rear panel of the UPS. Connect the other end of the USB cable to the device that will be monitoring/controlling the UPS. NOTE: Connecting to the communications port is optional. The UPS works properly without this connection.
SU1000Li Manual LED INDICATORS There are four LED indicators located on the front panel. Their function is as follows: Surge SELF TEST (Green): When illuminated, the surge suppression circuitry is functioning correctly. UPS Status UPS Self-Test Normal Boost Buck Self Low Battery Overload Normal Overload Low Battery Short/Fault Mode Over-Bat/Bat Fault Status LED and Alarm Table Green LED Yellow LED Red LED All LEDs cycle (each LED blinks 1/1.5 Seconds) AC Mode On Off Off 1-Blink/1.
SU1000Li Manual TROUBLESHOOTING Symptom UPS will not turn on Possible Cause On/Off button not pressed UPS operates in battery mode only, even though there is normal AC present Input AC circuit breaker is tripped Fault LED is illuminated The AC Mode LED is illuminated, but there is no output UPS has detected an internal fault The UPS is being controlled via its communications port UPS does not provide expected runtime The batteries may be weak or at the end of useful service life Bad Battery LED is
SU1000Li Manual REPLACING THE BATTERY (Qualified Service Personnel Only) Please read all warnings and cautions before attempting to service the batteries. WARNING! This UPS contains potentially hazardous voltages. Do not attempt to disassemble the UPS beyond the battery replacement procedure. This UPS contains no user serviceable parts. Repairs and battery replacement must be performed by Qualified Service Personnel Only. CAUTION: Do not open or mutilate batteries.
SU1000Li Manual SPECIFICATIONS AC Input Number of Phases: Single (2W + G) Power Cord: 6-ft. grounded, 3 wire, #14 line cord Input Voltage (Acceptable Input Voltage): 120VAC (0 - 160VAC) Input Voltage Range (Normal mode): 90 - 150VAC DC Start Capability: Yes, (defaults to 60Hz) Power Requirements (no load): 35 watts (charging), 15 watts (charged) AC Output (Normal Mode) Load Rating: 15 Amps @ 120 volts Load Power Factor: 0.
SU1000Li Manual Surge Protection Specifications Surge Protection: Advanced Series Mode® surge elimination Surge Energy Rating: 6,000 volts/3,000 amps Let through Voltage (6,000 volt surge): 0 volts UL 1449 Adjunct Classification Test Results: 1000 surges, 6000 volts, 3000 amps, B3 pulse; Measured suppressed voltage: 170 volts; no failures.
