Quick Start Guide SX-AX15E / SX-AX20E Quick Start © 2015 SurgeX/Electronic Systems Protection, Inc. | Technical Support: 800-645-9721 | surgex.
Quick Start Guide I. Connections 1. Connect Network: The Axess Elite supports 10/100 Ethernet using the cable supplied, or other suitable unshielded twisted pair (Cat 5) cabling. 2. Connect Powered Equipment: Connect the devices to be powered On and Off to the 8 receptacles located on the rear panel. If the connected equipment has a Power switch, leave it in the On position to allow the Axess Elite to control the power.
Quick Start Guide III. Line Interface 1. Command Line Interface (CLI): Many configuration parameters may be set using the Command Line Interface (CLI). The CLI is accessed through the network using a telnet client, or through the serial port. a. Open a telnet client and point it to the current IP Address of the Axess Elite. (Factory Default is DHCP Assigned, telnet Port 23) b. Connect to the Serial port. (Factory Default is 9600,8,n,1) c.
