Operation Manual
your Area Code and the Dial Prex if necessary. If you do not want to log all your ISDN
trafc, uncheck the Start ISDN Log option.
Activate Device denes how the ISDN interface should be started: At Boot Time causes
the ISDN driver to be initialized each time the system boots. Manually requires you to
load the ISDN driver as root with the command rcisdn start. On Hotplug, used
for PCMCIA or USB devices, loads the driver after the device is plugged in. When
nished with these settings, select OK.
In the next dialog, specify the interface type for your ISDN card and add ISPs to an
existing interface. Interfaces may be either the SyncPPP or the RawIP type, but most
ISPs operate in the SyncPPP mode, which is described below.
Figure 23.6
ISDN Interface Conguration
The number to enter for My Phone Number depends on your particular setup:
ISDN Card Directly Connected to Phone Outlet
A standard ISDN line provides three phone numbers (called multiple subscriber
numbers, or MSNs). If the subscriber asked for more, there may be up to 10. One
of these MSNs must be entered here, but without your area code. If you enter the
390 Reference