Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical data
- 5. Dimensional drawing
- 6. Determination of the installation point
- 7. Inlet and outlet sections
- 8. Sensor installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- 16. Appendix A - Analogue output
- 17. Appendix B - Modbus communication example
- 18. Appendix C - LRC and CRC calculation
8. Sensor installation
8. Sensor installation
Before installing the sensor, please make sure that all components listed
below are included in your package.
Qty Description Item no.
1 Sensor S695 4100
S695 4101
S695 4102
S695 4103
1 Sealing ring No P/N
1 Alignment key No P/N
2 M12 plug C219 0059
1 Instruction manual No P/N
1 Calibration certificate No P/N
8.1 Installation requirements
To install the sensor, a ball valve or a nozzle is needed.
• The inner thread must be G 1/2”.
• The diameter of the hole must be ≥ 13 mm, otherwise the shaft
can not be inserted.
S401 15