Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical data
- 5. Dimensional drawing
- 6. Determination of the installation point
- 7. Inlet and outlet sections
- 8. Sensor installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- 16. Appendix A - Analogue output
- 17. Appendix B - Modbus communication example
- 18. Appendix C - LRC and CRC calculation
10. Sensor display (option)
10. Sensor display (option)
With the Sensor display it is possible to show the value of the flow and
the consumption. Moreover it shows error messages and it is possible to
change the configuration setting of the sensor.
“Enter key” =
“Up key” =
“Down key” =
10.1 Starting process
After powered up, the display starts automatically with an initialisation
procedure. During the next eight seconds the display will show the
current software version and build the connection to the sensor. Now
the display goes to the standard mode, showing the online values.
Home page:
• Status bar
• Moving bar to indicate flow
value
• Measuring values
26 S401