Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical data
- 5. Dimensional drawing
- 6. Determination of the installation point
- 7. Inlet and outlet sections
- 8. Sensor installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- 16. Appendix A - Analogue output
- 17. Appendix B - Modbus communication example
- 18. Appendix C - LRC and CRC calculation
10. Sensor display (option)
Icons are shown in the status bar indicating status or warnings for the
sensor in service. The following table provides descriptions for these
icons.
Icon Description Icon Description
Calibration expired Pressure sensor
damaged
Temperature over
operating range
Temperature sensor
damaged
Flows over
measuring range
Flow direction
Pressure over
operating range
10.2 Configuration using the display
The following settings can be changed via display or service software.
• Pipe diameter – for flow calculation.
• Gas type – select the gas to be measured.
• Flow unit – select unit for flow value.
For this please observe the following steps:
1. Please press “Enter” (>3s) key to
check and change settings
(unlock code:12).
2. Use the “Up” and “Down” key on
the keyboard to choose the
setting which should be changed.
3. Also use these two buttons to
select desired entry box or
adjust the values.
4. Please press “Enter” button to
confirm the changes.
S401 27