Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical Data
- 5. Dimensional drawing
- 6. Installation considerations
- 7. Inlet and Outlet sections
- 8. Sensor Installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App—S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- Appendix A Analogue output
- Appendix B Modbus communication example
- Appendix C LRC and CRC calculation
10. Sensor display (option)
10. Sensor display (option)
The Sensor display shows values of the flow and the consumption.
Moreover it shows error messages and enables you to change the
configuration settings for the sensor.
“Enter key” =
“Up key” =
“Down key” =
10.1 Starting process
After powered up, the display starts automatically with an initialization
procedure. During the next eight seconds the display shows the current
software version and starts to build connection with the sensor. Finally, the
display enters the standard mode, showing the online values as shown below.
Home page:
• Status bar
• Moving bar to indicate flow
value
• Measurement values
S 421 25