Operation Manual
Table Of Contents
- 1. Safety instructions
- 2. Application
- 3. Features
- 4. Technical Data
- 5. Dimensional drawing
- 6. Installation considerations
- 7. Inlet and Outlet sections
- 8. Sensor Installation
- 9. Sensor signal outputs
- 10. Sensor display (option)
- 11. Service App—S4C-FS
- 12. Calibration
- 13. Maintenance
- 14. Disposal or waste
- 15. Warranty
- Appendix A Analogue output
- Appendix B Modbus communication example
- Appendix C LRC and CRC calculation
10. Sensor display (option)
10.2 Configuration using the display
The following settings can be changed via display or service software.
• Gas type – select the gas to be measured.
• Flow unit – select unit for flow value.
For this please observe the following steps:
1. Press “Enter” (>3s) key to
check and change settings
(unlock code:12).
2. Use the “Up” and “Down” key
on the keyboard to choose
the setting which should be
changed.
3. Use these two buttons to
select a desired entry box or
adjust the values.
4. Press the “Enter” button to
confirm the changes.
26 S 421