Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
6 Technical data
6.3 Output-signals
Analogue output Signal: 4 ... 20 mA, isolated
Scaling: 0 to max flow
Max load: 250R
Pulse output 1 pulse per consumption unit, isolated switch,
max. 30 VDC, 200 mA (pulse length: 10 ... 120
ms, depending on flow rate)
Modbus output See chapter 10.3
6.4 Accuracy
Accuracy* ±(2% of reading + 0.3% FS)
Temperature drift: < 0.05%/K
Stated accuracy at Ambient/process temperature 23°C ± 3°C
Ambient/process humidity <90%
Process pressure at 0.6 MPa
Repeatability ±0.25% of reading
*Specified accuracy is valid only within the minimum and maximum flow
rates that are indicated in section 6.5.
10 S402