Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
9 Installing the sensor
9 Installing the sensor
Before installing the sensor, please make sure that all components listed
below are included in your package.
Qty Description Item no.
1 Sensor S695 4105
1 Copper gasket sealing ring NA
1 Alignment key NA
1 Depending on orders:
M12 5-pore plug or M12
cable
5-pore plug: C219 0059
Cable including a 5-pore plug:
A553 0104/A553 0105
Cable including a 6-pore plug:
A553 0106
1 Instruction manual NA
1 Calibration certificate NA
9.1 Installation requirements
To install the sensor, a ball valve or a nozzle is needed.
• The inner thread must be G 1/2”.
• The diameter of the hole must be ≥ 13 mm, otherwise the shaft
cannot be inserted.
16 S402