Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
9 Installing the sensor
Pin assignment of the 6-pin M12 connector
Output type Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6
4 ... 20 mA
plus Pulse
(P/N: A1415)
-I -VB +VB SW SW +I
Wire colour blue white red yellow green black
Legend:
GND: Ground for Modbus SW: Isolated pulse output
-VB: Negative supply voltage D+: Modbus data +
+VB: Positive supply voltage D-: Modbus data -
+I: Positive 4 ... 20 mA signal MB: MBus data
-I: Negative 4 ... 20 mA signal NA: Not applicable
+P: Pulse output
ATTENTION!
Do not screw the M12 plug using force. Otherwise, it
may damage the connecting pins.
22 S402