Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
1 Safety instructions
ATTENTION!
Permitted operating parameters!
Observe the permitted operating parameters, any
operation exceeding this parameters can lead to
malfunctions and may lead to damage on the
instrument or the system.
• Do not exceed the permitted operating parameters.
• Make sure the product is operated in its permitted limitations.
• Do not exceed or undercut the permitted storage and operation
temperature and pressure.
• The product should be maintained and calibrated frequently, at
least annually.
General safety instructions
• It is not allowed to use the product in explosive areas.
• Please observe the national regulations before/during installation
and operation.
Remarks
• It is not allowed to disassemble the product.
• Always use spanner to mount the product properly.
ATTENTION!
Measurement values can be affected by malfunction!
The product must be installed properly and
frequently maintained, otherwise it may lead to
wrong measurement values, which can lead to
wrong result.
• Always observe the direction of the flow when installing the
sensor. The direction is indicated on the housing.
• Do not exceed the maximum operation temperature at the sensor
probe tip.
• Avoid condensation on the sensor element because this will affect
accuracy enormously.
S402 5