Operation Manual
Table Of Contents
- 1 Safety instructions
- 2 Registered trademarks
- 3 RF exposure information and statement
- 4 Application
- 5 Features
- 6 Technical data
- 7 Dimensional drawing
- 8 Determining the installation point
- 9 Installing the sensor
- 10 Sensor signal outputs
- 11 Service App S4C-FS
- 12 Calibration
- 13 Maintenance
- 14 Disposal or waste
- 15 Appendix A - Modbus communication example
- 空白页面
4 Application
4 Application
The S402 is a flow sensor that is designed to measure the consumption
of compressed air and gases within the permissible operating
parameters. These parameters can be found in chapter 6 Technical data .
The S402 can measure the following values:
• Volumetric flow of the compressed air or gas.
• Total consumption of the compressed air or gas.
The default factory settings are: Volumetric flow in m
3
/h and Total
Consumption in m
3
. Other units can be made available using the mobile
service app S4C-FS.
The S402 flow sensor is mainly used in compressed air systems in
industrial environments. The S402 is not designed to be used in
explosive areas. For the use in explosive areas please contact the
manufacturer.
5 Features
• Insertion type flow sensor for easy installations under pressure
through a ball valve.
• Thermal mass flow measurement, virtually independent of
pressure and temperature changes.
• IP65 casing provides robust protection in the industrial
environment.
• Very fast response time.
• High accuracy and wide measuring ranges. Special ranges on
request.
• Tube diameters from 1/2” up to 12”, larger diameters on request.
• Android app for remote configuration and online reading
• Various interface available such as analogue, pulse, Modbus/RTU,
and MBUS.
8 S402