Owner's Manual

Alarm reasonAlarm type
PO
2
value is smaller than 0.18 bar. In DIVE Mixed
and DIVE CCR modes only. The depth is too shallow
and the ambient pressure is too low for the current
gas. The oxygen content is too low to keep you con-
scious. You should immediately switch the gas.
High priority alarm followed
by "Change gas" beep, soun-
ded two times. The PO
2
value
blinks.
Decompression ceiling depth is exceeded. You should
immediately descend to, or below, the ceiling
High priority alarm followed
by "Start descending" beep,
repeated for the maximum of
three minutes. The Er symbol
blinks and an arrow points
downwards.
Maximum allowed ascent rate, 10 m per min / 33 ft per
min, is exceeded. Slow the ascend rate down.
High priority alarm, sounded
three times. The SLOW sym-
bol blinks.
No-decompression dive turns into a decompression
stop dive. Depth is below the decompression floor
level. You should ascend to, or above, the floor.
Low priority alarm followed by
"Start ascending" beep,
sounded two times. The ASC
TIME symbol blinks and an
arrow points upwards.
42