Manual
Table Of Contents
- 1. Introduction to Suunto Memory Belt
- 2. Getting started with suunto Memory Belt
- 3. Downloading and analyzing data recorded with Suunto Memory Belt
- 4. Errors and warnings
- 5. Installing Suunto software
- 6. Using Suunto Memory Belt with other Suunto devices
- 7. Technical specifications
- 8. Intellectual property
- 9. Disclaimers
- 10. Disposal of the device
10
4. ERRORS AND WARNINGS
Suunto Memory Belt communicates errors and warnings with long orange and red flashes
and long beeps.
LOW BATTERY
If the battery is low, a signal of 2 long beeps and long, red flashes is repeated 3 times.This is
followed by a flash every 4 seconds and indicates that you should replace the battery. As the
battery is low, not empty, Suunto Memory Belt continues to operate normally.
If the battery is too low to operate, the device will switch to sleep mode, and 2 long beeps and
2 long, red flashes will indicate that you must replace the battery before you can continue to
use your Suunto Memory Belt. This signal continues until you take off the belt.
If you don’t need to transmit data with your Suunto Memory Belt, it is worth turning off the belt’s
transmitting function with the PC software, as transmitting data has a significant impact on battery
life.
2 long, red, then 1 every
4 seconds
2 long
battery low, still reading heart
rate