User's Manual
Table Of Contents
- 1. SAFETY
- 2. Welcome
- 3. Introduction
- 4. Getting started
- 5. General settings
- 6. Using time mode
- 7. Using ALTI & BARO mode
- 8. Using compass mode
- 9. Using memory
- 10. Care and support
- 11. Specifications
Log height dierence: shows the measured altitude dierence between a log starting point
and a log finishing point with the following icons:
In the additional views:
is displayed when your altitude is above the starting point.
is displayed when your altitude is the same as at the starting point.
is displayed when your altitude is below the starting point.
is displayed when you view how much you have ascended from the log start.
is displayed when you view how much you have descended from the log start.
Altitude points are recorded according to the recording interval you have chosen (see 9.3.
Choosing recording interval).
To change the recording rate:
1. In MENU, select MEMORY.
2. Select REC INTERVAL.
3. Change the recording rate with [+] and [- Light] .
NOTE: An estimation of how much time you can record is shown in the lower part of the
display when you browse between the recording rates. The actual recording durations may
vary slightly depending on your activity during the recording period.
You can access your history of recorded logs, including log details, from LOGBOOK in MENU
(see 9.2. Viewing and locking logs).
TIP: When you have stopped the log recorder, you can enter the logbook and view your
current recordings before you reset the recorder.
You’re going on another mountain hike. This time you want to record how much you ascend
and descend so as to compare the figures with previous hikes. You set your to the
altimeterAltimeter profile and start the log recorder when you begin the hike. After the hike
you stop your log recorder and reset it . Now you can compare it with your previous logs.
7.6. Using barometer profile
The BAROMETER profile shows the current sea level air pressure. This is based on the
reference values given and the constantly measured absolute air pressure. Changes in sea
level air pressure are presented graphically in the middle of the display. The display shows
the recording of the last 24 hours with a recording interval of 30 minutes.
When the BAROMETER profile is activated, the word BARO is underlined on the display.
When the BAROMETER
profile is activated, you can access the following views with [View] :
•
Temperature: measures the current temperature
•
Log recorder: records the altitude changes in logs
•
Altitude reference: shows the altitude reference value
•
Time: shows the current time
Suunto Core
18