User Manual

2. Select Pair sensor to get the list of sensor types.
3. Press the lower right button to scroll through the list and select the sensor type with the
middle button.
4. Follow the instructions in the watch to complete pairing (refer to sensor or POD manual if
needed), pressing the middle button to advance to the next step.
If the POD has required settings, such as crank length for a power POD, you are prompted to
enter a value during the pairing process.
Once the POD or sensor is paired, your watch searches for it as soon as you select a sport
mode that uses that sensor type.
You can see the full list of paired devices in your watch from the settings under Connectivity »
Paired devices.
From this list, you can remove (unpair) the device if needed. Select the device you want to
remove, and tap Forget.
5.13.1. Calibrating bike POD
For bike PODs, you need to set the wheel circumference in your watch. The circumference
shall be in millimeters and it is done as a step in the calibration. If you change the wheels (with
new circumference) of your bike, the wheel circumference setting in the watch must also be
changed.
To change the wheel circumference:
1. In settings, go to Connectivity » Paired devices.
2. Select Bike POD.
3. Select the new wheel circumference.
5.13.2. Calibrating foot POD
When you pair a foot POD, your watch automatically calibrates the POD using GPS. We
recommend using the automatic calibration, but you can disable it if needed from the POD
settings under Connectivity » Paired devices.
For the
first calibration with GPS, you should select a sport mode where the foot POD is used
and the GPS accuracy is set to Best. Start the recording and run at a steady pace on a level
surface, if possible, for at least 15 minutes.
Run at your normal average pace for the initial calibration, and then stop the exercise
recording. The next time you use the foot POD, the calibration is ready.
Your watch automatically re-calibrates the foot POD as needed whenever GPS speed is
available.
Suunto 5 Peak
42