User Manual
Table Of Contents
- 1. Intended use
- 2. SAFETY
- 3. Getting started
- 4. Settings
- 4.1. Button lock and screen dimming
- 4.2. Backlight
- 4.3. Tones and vibration
- 4.4. Bluetooth connectivity
- 4.5. Airplane mode
- 4.6. Do Not Disturb mode
- 4.7. Notifications
- 4.8. Time and date
- 4.9. Language and unit system
- 4.10. Watch faces
- 4.11. Sunrise and sunset alarms
- 4.12. Power saving
- 4.13. Position formats
- 4.14. Device info
- 5. Features
- 5.1. Recording an exercise
- 5.2. Media controls
- 5.3. Logbook
- 5.4. Navigation
- 5.5. Daily activity
- 5.6. Training insight
- 5.7. Adaptive training guidance
- 5.8. Recovery
- 5.9. Sleep tracking
- 5.10. Stress and recovery
- 5.11. Fitness level
- 5.12. Chest heart rate sensor
- 5.13. Pairing PODs and sensors
- 5.14. Timers
- 5.15. Intensity zones
- 5.16. FusedSpeed
- 6. SuuntoPlus™
- 7. Care and support
- 8. Reference
The display shows your heart rate over 12 hours as a graph. The graph is plotted using your
average heart rate based on 24-minute time slots. In addition, by pressing the lower right
button, you get an estimation of your average hourly calorie consumption rate and your
lowest heart rate during the 12- hour period.
Your minimum heart rate from the last 12 hours is a good indicator of your recovery state. If it
is higher than normal, you probably are not yet fully recovered from your last training session.
If you record an exercise, the daily HR values reflect the elevated heart rate and calorie
consumption from your training. But keep in mind that the graph and consumption rates are
averages. If your heart rate peaks at 200 bpm while exercising, the graph does not show that
maximum value, but rather the average from the 24 minutes during which you hit that peak
rate.
Before you can see the daily HR display, you need to activate the daily HR feature. You can
toggle the feature on or
o from the settings under Activity. If you are in the daily HR display,
you can also access the activity settings by keeping the middle button pressed.
With the daily HR feature on, your watch activates the optical heart rate sensor on a regular
basis to check your heart rate. This slightly increases battery power consumption.
Once activated, your watch needs 24 minutes before it can start display daily HR information.
To view daily HR:
1. From the watch face view, press the lower right button to scroll to the instant HR display.
2. Press the middle button to enter the daily HR display.
3. Press the lower right button to see your calorie consumption.
NOTE: After a period of inactivity, such as when you are not wearing the watch or
sleeping soundly, the watch goes into hibernation mode and turns o the optical heart rate
sensor. If you want to get heart rate tracking during the night, activate Do Not Disturb mode
(see 4.6. Do Not Disturb mode).
5.6. Training insight
Your watch provides an overview of your training activity.
Press the lower right button to scroll to the training insight view
Suunto 5 Peak
34