User's Manual

Document No.:
11 / 91
Chapter IV Instrument Installation
4.1 Unpacking inspection
After the instrument is unpacked, first confirm that there is no transportation damage of
the instrument, then inspect according to the "packing list" and install according to the
requirements and methods specified in "4.2".
4.2 Installation
4.2.1Schematic diagram of the base for the scanning device of the instrument
Figure 4-1 Schematic diagram of the base for M4-HD scanning device
4.2.2 Installation and disassembly of Bluetooth printer
Installation of Bluetooth printer:
●First, adjust the power charging port of the printer to be consistent with the direction of the
preformed hole on the base, then place the printer ③ into the bottom case frame.