User's Manual

Document No.:
36 / 91
startup, the tablet computer and the scanning device will automatically connect. If it is set as
Auto Connect off (i.e., the manual connect) on the password management interface, under
the manual connect mode, it can be set as Use Wifi Password on (i.e., Use Wifi Password
is required for manual connect) on the password management interface. Use Wifi Password
shall be entered for connecting the tablet computer and the scanning device after each
startup. The original password for wifi connection is: 00000000. If it is set as Use Wifi
Password off (i.e., no Use Wifi Password is required for connect) on the password
management interface
6.3.1 Gender selection
Click the App icon on the tablet computer to enter the startup interface (Figure
5-1), which will stay for about 4 seconds and then automatically enter the main interface
(Figure 5-2). The patient gender is Male ( ) by default. Click area to switch the
gender: Male , Female , FemaleH , Child and Phantom
.
6.3.2 Bladder pre-scanning
Apply the coupling agent to the contact area between the probe surface of the
scanning device of the instrument and the patient, and place the instrument probe on the
patient's bladder. Press the scan key, to display the real-time bladder B-ultrasound image
(Figure 5-5-1) of the patient or the bladder section diagram (Figure 5-6-1) on the screen of
the bladder scanner or display the real-time bladder projection position diagram of the
patient while displaying the bladder B-ultrasound image (Figure 5-7-1) of the patient at the
bottom right of the display screen, and enter the pre-scanning state.
When selecting the “expert mode”, during pre-scanning, the operator can observe the
bladder B-ultrasound image of the patient, move the probe to center the image and
maximize the area.
When selecting the “easy mode”, during pre-scanning, the operator can observe the
bladder section of the patient, move the probe to make the center of the bladder section to