User's Manual

INSTALL MANUAL
Page 6 of 6
automatically. LED light will return into green or red depended on pressure value until
information of the sensor can be received.
5
．Setting Guide
1）Sensor ID Setting
1) Press ID key and hold it for 3 seconds long, then release the key, as shown
below. Digital “1” began to flash, at this time you can adjust it to the tire number
you want by key ,such as ↑ 、 ↓ , and then press ENTR . If you
want to exit the setting of ID modified, adjust to” E” and then press ENTR to
exit.
2) Then come into the interface of the tire unique ID you have chosen, the first digit
on the right will flash, adjust the digit by ↑ 、↓ and adjust the position of
digit by → 、 ←
After adjustment, press ENTR to save the specified unique ID, then automatically
come into next tire number, repeat step 1 to set other ID.
2
）Low Threshold Pressure Setting
Press P Key and hold it for 3 seconds long, then release it, picture will be shown
like as below, the first digit on the right will flash, adjust the digit flashing by
↑ 、 ↓ and adjust the position of digit by → 、 ← After adjustment, press
ENTR to save current setting.
Note:
1. Unit of pressure is indicated to be P or b, representing Psi or bar.
2. Value set is relative pressure value.
3. It is suggested that pressure value of tire on crane is set to be 9.50bar.