User's Manual

ManualsBrandsSuzhou Sate Auto Electronic ManualsAutomotiveTIRE PRESSURE MONITORING SYSTEM

User Manual

FCC ID: TTETPMS09S22

TPMS1209TS22 is a full-time direct tire pressure monitoring system which includes

one wireless Monitor. User can choose 2 to 36 Transmitters to install on their vehicles

as needed.

The Transmitter can be screwed onto the tire instead of the cap of the valve and then

senses the pressure inside the tire all the time and transmits the pressure information

data to the Booster by RF technology. The Booster then signifies the signal and

transmits it to the Monitor. The Monitor can receive and deal with the data, then

display the pressure on the screen. The Monitor can issue different alarms if the tire

pressure is at an improper level based on the standard pressure.

TPMS1209TS22 can sense and display the tire pressure all the time and can issue an

alarm when the tire pressure is improper, so as to notify the driver to treat the problem

and avoid tire busting or tire damage.

Through TPMS, the driver can keep the tire running under a proper pressure so as to

avoid excess gasoline consumption and keep the vehicle in an easily controlled state.

Transmitter and the Security Lock

Installation of the Transmitter

Before installing the Transmitter, the Monitor must be powered on

and then it will be under the “waiting” mode (waiting for receiving

the ID information). At this time, if the Transmitter is installed, its

ID information will be received and recorded by the Monitor.

However, the Monitor can only record one Transmitter’s ID

information each time. So before another Transmitter is installed,

the ID information of the previous installed Transmitter must be received and

recorded by the Monitor.

Summary of content (4 pages)

PAGE 1
User Manual FCC ID: TTETPMS09S22 TPMS1209TS22 is a full-time direct tire pressure monitoring system which includes one wireless Monitor. User can choose 2 to 36 Transmitters to install on their vehicles as needed. The Transmitter can be screwed onto the tire instead of the cap of the valve and then senses the pressure inside the tire all the time and transmits the pressure information data to the Booster by RF technology. The Booster then signifies the signal and transmits it to the Monitor.
PAGE 2
The Installation steps of the Transmitter are as follows: 1. Inflate the tire to the standard pressure recommended by the manufacturer. 2. Take out a Transmitter and check whether the rubber seal is placed smoothly and suitably inside the copper stem of the valve. 3. Screw off the current cap of the valve on the tire. Note: IMPORTANT. TPMS1209TS22 provides a Lock for each Transmitter to prevent the Transmitter from falling off. Whether use the Lock or not won’t influence the work of the Transmitter.
PAGE 3
TPMS1209TS22 has a Security Lock and a special tool for the lock for each Transmitter to prevent the Transmitter from loosing or falling off. The Security Lock has three sockets on it and each socket has a bolt in it, as shown in the above figure. The function of the lock is to connect the Transmitter and the Lock by connecting the meshing part of them, and then fasten the lock to the valve by the three bolts.
PAGE 4
How to inflate the tire with a locked Transmitter BEFORE inflating the tire, please 1) Use the special tool to loose the three bolts inside the sockets on the Lock. 2) Screw off the Transmitter. 3) Remove the Transmitter together with the Security Lock from the Valve Note: 1.The Security Lock will not influence the Transmitter’s work, you can choose using the Lock or not while you install the Transmitter. 2. The tires need to be re-balanced after installing the Transmitter or the Transmitter with the Lock.